VCS-2D-HPINSTALLATION & OPERATION GUIDENILESMODELVCS-2D-HPHIGH POWER STEREO VOLUME CONTROLVCS-2D-HPDS00134A/VCS-2D-HP 2/4/99 4:10 PM Page 12
4. Plug the connectors into the VCS-2D-HP as shown in(Figure 5)5. Secure the VCS-2D-HP to the electrical box or p-ring.Insert the 11/4” long device sc
Operation1. Make sure the amplifier or receiver power is OFF and setthe volume to minimum.2. Set the VCS-2D-HP volume to maximum (fully clockwise). 3.
NILES®Niles Audio Corporationwww.nilesaudio.com12331 S.W. 130 Street Miami, Florida, 33186Tel: (305) 238-4373Fax: (305) 238-0185©1999 Niles Audio Corp
IntroductionThe VCS-2D-HP is a wall-mount, Decora®style speaker vol-ume control. It connects between the speaker-level outputof an amplifier, speaker
of attenuation instead of 8. Steps 11-6 attenuate -3 dB perstep; steps 5-2 are -6 dB per step. Step 12 is “full-on” and step1 is “full-off”. The VCS-
● Isolated left and right channel grounds make it safe for use with any amplifier.● May be used with 4, 6, or 8 ohm speaker systems.● Ideal for both h
of the wall. In some instances, the use of a p-ring may beinappropriate, such as in a retro-fit (existing) installation, orwhen building codes require
VCS-2D-HP Mounting LocationConvenient mounting locations for the VCS-2D-HP are:● Near entryways or exits● Near a desk● At your bedside● Close to a tel
1. Obtain the VCS-2D-HP knob and Decora-style insert inthe desired color from your Niles dealer.2. Holding the VCS-2D-HP control as shown in (Figure 1
7(a) Electrical Box(b) Speaker Wire(c) VCS-2D-HP Volume Control (supplied)(d) Snap-on Color Insert (supplied)(e) Knob (supplied)(f) Device Screws (2 s
InstallationIf you are installing the VCS-2D-HP into an existing wall,take time to consider any possible obstructions which maybe hidden inside the wa
Comments to this Manuals